Roper Washer Spezifikationen PDF herunterladen (Seite 12)

12

OPERATING YOUR WASHER

Understanding what happens in each cycle

When the Cycle Control Knob is set to a

number and pulled out, the washer fills

before agitation and timing start. The washer

begins agitating immediately after filling;

agitation occurs with the washer lid up

or down.

After agitation starts, the Cycle Control

Knob turns clockwise until it points to an

OFF area and the cycle ends.

Fill

▼

Rinse

▼

Drain-No agitation

▼

Spin-Spray rinse

▼

Spin

▼

Off

Fill

▼

Wash selected time

▼

Drain*

No agitation

▼

Spin

▼

*On some models, the Permanent Press

cycle partially drains, fills, agitates briefly,

and drains.

WASH RINSE

Understanding normal washer sounds

Your new washer may make sounds that

your old one didn’t. Because the sounds are

unfamiliar, you may be concerned about

them. Don’t be; most of them are normal.

The following describes some of the sounds

you may hear and what causes them.

During washing

When you select a small load size setting

for a small wash load, the water level in your

washer is lower. With this lower water level,

you may hear a clicking sound from the

upper portion of the agitator.

During drain

The rate that water is drained from your

washer depends on your installation. If water

is drained quickly from the washer, you may

hear air being pulled through the pump. This

happens during the end of draining.

After drain and before spin

When the cycle changes from draining to

spinning, you may hear gears engaging.

NOTE: The washer pauses briefly throughout

each cycle. These pauses are normal for

washer operation.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare