Roper Gas 120-Volt Bedienungsanleitung

INSTALLATION INSTRUCTIONS30" (76 CM) FREESTANDING GAS RANGESRANGE SAFETYTable of ContentsRANGE SAFETY ...

10Check Operation of Oven Broil Burner1. Close the oven door.2. Press the BROIL pad.3. Press the START pad.The oven burner should light within 8 secon

11GAS CONVERSIONSLP Gas ConversionTo Convert Gas Pressure Regulator1. Ensure that the manual shutoff valve is in the closed position and the power sup

123. Apply masking tape to the end of a ⁵⁄₁₆" nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver

13Replace Oven Racks & Storage orWarming DrawerReplace oven racks in oven cavity. Insert storage drawer or warming drawer into slide rails on side

143. Apply masking tape to the end of a ⁵⁄₁₆" nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver

15Notes

ANTI-TIP BRACKET TEMPLATECut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall.Left edgeTop

2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the safety instructions pro

3Location RequirementsIMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. It is the insta

4Installation ClearancesCabinet opening dimensions shown are for 25" (64 cm) countertop depth, 24" (61 cm), base cabinet depth and36" (

5Gas Supply RequirementsObserve all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In

6Burner Input RequirementsInput ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m). For elevations above 2,000

77. Align anti-tip bracket holes with holes in floor. Fasten anti-tip bracket with screws provided.Depending on the thickness of your flooring, longer

8Typical flexible connection1. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B

9Adjust Flame Height Adjust the height of top burner flames. The cooktop “low” burner flame should be a steady blue flame approximately ¼" (0.64